Page 13 of 21 Scout mini - Manual Rev.1.0
PS/2 to serial mouse translation, wheel mouse
You can use some computers with PS/2 mouse interfaces and some computers with serial interfaces.
You must issue this command on each computer that is serial. You must switch to each computer and
issue the command.
To configure a computer for a serial mouse, press and release the left Control Key, type Q1, and
press <Enter>. Follow with the Keep command to save the new setting in the unit’s non-volatile
memory. To restore a computer that was previously set to serial to regular PS/2, use Q0 instead of
Q1.
Whether a computer uses a PS/2 wheel mouse or a regular PS/2 mouse is learned by Scout mini
when the computer loads its mouse driver. This will override any previous setting. You can tell Scout
mini to change its PS/2 communication to regular or wheel with the Q command. You can also save it
to non-volatile memory.
To configure a computer for a wheel mouse, press and release the left Control Key, type Q2, and
press <Enter>. Follow with the Keep command to save the new setting in the unit’s non-volatile
memory. To restore a computer that was previously set to wheel mouse to regular PS/2, use Q0
instead of Q2.
Null command of PS/2 mouse
This command is used to re-synchronize an out-of-sync PS/2 mouse. Such a condition can result due
to transients, spurious power-up effects, or plugging and unplugging of cables with live equipment.
The command may need to be entered once or twice, depending if the mouse is out-of-sync by one or
two bytes. Microsoft's mouse driver version 9.01 corrects this inadequacy of previous drivers and
renders this command unnecessary. To issue the command, press and release the left Control Key,
then type N.
ROM identification command
This command is used to identify the revision level of Scout mini firmware currently installed. Before
entering this command, your currently selected CPU should be at a command prompt, so that when
the Scout mini sends the ROM revision level, the result will be displayed. To issue the command,
press and release the left Control Key, then type I. Scout mini will send back its current firmware
revision level.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels